| Specifications |
Resistance Values: 1  to 2M other Value on request |
| Resistance Tolerance: 10% Std., 1%, 2%, 5% other on request |
| Temperature Coefficient: ±100ppm/°C typ. other on request |
| Max. Working Voltage: 5,000V DC, higher voltage on request, not exceeding max. power |
| Single Shot Voltage: Up to 12kV Normwave (1.5/50µsec) |
| Insulation Resistance: 10G min. at 500V |
| Creeping Distance: 42mm min. |
Inductance:  50nH |
| Capacity/Ground: 110pF |
| Capacity/Resistive: 40pF |
| Operation Temperature: -55°C to +155°C |
| Max. Torque for Contacts: 2Nm |
| Max. Torque for Mounting: 18Nm |
| Rating Power: 250W at 50°C Heatsink Temperature |
| Higher Power: 600 Watt at 5°C Heatsink Temperature |
| Dielectric Strength: Up to 12kV |
| Termination to Contacts: M5 screws |
| Required thermal transfer compound of heat conductivity: 1W/°Cm |
| Flatness of Heat Sink: 0.05mm |
| Roughness of Heat sink surface: 6.4µm |
| Isolation Voltage (Terminal to Heatsink): 7kVms |
Other Requirements:
(1) Insulating material is not necessary between flange and resistors, flange and resistor are separated by alumina substrate.
(2) At surface mount soldering, temperature profile in tab shall not exceed 220°C |
| The described specifications & dimensions subject to change without notice. |
